Ignite Thick Power Stretch Donut Cock Ring - Stretchy Donut Cockring Single or Double Pack

$2.95 - $4.95
SKU:
EOPSN9511
OR
Adding to cart… The item has been added

Cock rings have been in existence for over 2000 years and were used then as they still are today. To help maintain and enhance an erection , boosting sexual pleasure and as decorative jewellery for the manhood. There are a wide number of materials used today just as there was then with rubber, leather and metal being the most popular materials used to produce modern cockrings.


The stretchy TPE rubber based cock rings are one of the most popular styles of cockrings. They are a great introduction to the world of cock rings as they are easy to get on and the soft jelly like material gives a comfortable fit. The stretchy nature of the phthalate-free TPE makes it easy to find the right fit.


The Ignite Power Stretch Donut Cock Ring is a super stretchy TPE rubber donut style rings that you can wear on your manhood and balls whichever way you want. Each ring has an internal ring diameter of 0.6 inches or 16mm and is 0.5 inch thick. These rings will give a nice tight fit but will also stretch up to 5 times their size so you can wear them how you want.

Wear one around your shaft, base and balls or wear all three on your balls for a really good stretch and tug on your balls. The beauty of this cock ring multipack is that you can mix and match them how you want. 

These cock rings are super easy to get on because of the amount of stretch that it have. Just pop your manhood through the hole and then stretch it over your your balls so that it sits nicely behind them close to your body. Or you might find it easier to put your balls through first and then stretch over your manhood.


Fitting Advice


As always the fit is going to depend on your personal preference and how tight a fit you like from your cock ring. These cock rings should give any man a nice firm fit. If you are bigger than average then the extra stretch should help you get them on.  Remember that you ideally want the inner ring to be slightly smaller than the circumference around the base of your manhood and balls.